****x1 18650 Battery Not Included!****
Selectable voltage from 3.0V~6.0V in 0.1V increments
Lambo 4.0 Body Unit Dimensions: 5.15"L x 0.86"D
Resistance Check: Push the large activation button 5 times and the LCD will display the resistance of the attached atomizer or cartomizer.
Low Resistance Atomizers: The Lambo will work with atomizer of 1.0 ohm or higher.
Ego Compatible: The Lambo is compatible with Joye Ego Series Atomizers without the use of an adapter. Ego CE4 Plus will not fit.
Spring Loaded Center Post: Shake the unit and it may rattle. Don't be alarmed. This faint noise is due to the newly designed spring loaded center post (seen here). This new center post will preventing "post-pulling" and other related contact issues.
Power on/Off Button: hold the button down for 5 seconds to turn the device on, hold the button again for 5 seconds to turn the device off.
+ Button: On press, increases voltage by 0.1V increments between 3.0V~6.0V.
- Button: On press, decreases voltage by 0.1V increments between 3.0V~6.0V.
+ and – Button: Press and hold both buttons for five second to disable the + and – button, locking the device on the voltage it is currently set at.
Regulated output: Keeps the voltage the same with each puff regardless of the remaining battery power. As the battery drains, the device will keep the voltage consistent.
10 Second Cutoff timer: If the activation button is held down for 10 seconds or longer, the Lambo 4.0 will shut itself off until the button is released. To prevent overheating the atomizer and the device.
Short Circuit/Atomizer Protection: The Lambo 4.0 can recognize an atomizer with too low of a resistance for the current voltage setting and will drop the voltage to 3.7V to protect both the battery and atomizer. If the atomizer is too low or shorted out the LCD will display "F1" and the device will shut off until the issue is corrected.
Reverse Battery Protection: Protects the device in case you put the battery in the device backwards
Battery Monitoring/Over-Discharge Protection: The device will monitor the battery voltage and automatically turn off when the battery is discharged, preventing damage to the battery by overly depleting it.
Battery Voltage Meter: The Lambo 4.0 has a voltage meter built in, simply press the red power button 6 times and it will display the voltage of the battery for a few seconds. This way you can monitor the power left in the battery before it needs to be recharged. 18650 batteries provide 4.2V at peak charge and over the life of the battery that voltage will decrease to about 3.3V level before needing to be recharged. This will help you monitor the life cycle of the battery. The LCD screen will flash when the battery needs to be recharged, and will stop powering the device.
Amperage Limiting: The device should monitor and shut itself off if it detects any excessive over-current conditions.
Vent hole on the bottom of the device for added safety